Licensed · Insured · Free Estimates

Fascia & Soffit Repair on a residential street in Meridian, Idaho
Licensed Idaho Contractor

Fascia & Soffit Repair in Meridian, ID

Meridian is one of the fastest-growing cities in Idaho, with new construction subdivisions across the south and west sides and established trees in older neighborhoods. Larger homes and steeper rooflines benefit from oversized 6-inch gutters and properly routed downspouts.

Free on-site estimate · No-pressure quote · Same crew start to finish

QUICK ANSWER

Fascia and soffit repair in the Treasure Valley generally tracks national pro ranges — roughly $6–$20 per linear foot for sound-wood replacement and about $10–$23 per foot where rot is involved. We tear out the failed board, treat the rafter tails behind it, rebuild on rot-resistant material, and re-hang your gutters off solid wood.

  • 5″ & 6″ K-Style
  • Half-Round
  • Aluminum
  • Color-Matched
  • Hidden Hangers

LOCAL CONTEXT

Why Meridian homes need fascia & soffit.

Meridian shares Boise's freeze-thaw cycle but tends to see more wind across newer subdivisions, which stresses fasteners and pulls sections loose on homes built with builder-grade gutters and nails.

In Meridian, this typically means homes in Downtown Meridian and The Village, we provide the same on-site estimate and written quote we deliver across the Treasure Valley.

  • Original builder fasteners pull loose around year 5-10 as the home settles and fascia dries.
  • Builder-grade 5-inch gutters on production homes are undersized for steeper modern rooflines — overflow at corners is common.
  • New-build landscaping (mulch + bark) plus surrounding ag-land dust accumulates in gutters faster than expected.

OUR APPROACH

How we handle fascia & soffit in Meridian.

  1. Inspection and rot mapping

    We probe the fascia and soffit to find where the wood has gone soft, trace how far the decay has spread, and check the rafter tails behind the boards. Because fascia rot is usually gutter-driven, we also look at why water is reaching the wood — overflow, back-pitch, a pulled section, or a failed downspout — so the repair fixes the cause, not just the symptom.

  2. Gutter detachment and tear-out

    We detach the affected gutter runs, then remove the rotted fascia board and any decayed soffit panels. Off comes everything that's soft, spongy, or showing the cascade staining where water has been dripping from the fascia onto the soffit.

  3. Rafter tail treatment and substrate prep

    With the boards off, we inspect and treat the exposed rafter tails and sub-fascia. Any framing that's begun to decay from prolonged wetness is addressed before we close the eave back up — covering rot doesn't stop it.

  4. Rebuild on rot-resistant material

    New fascia and soffit go up in the material you chose — PVC, composite, cement/Hardie, or aluminum-wrapped wood — sized and fastened to give the gutters a solid nailing surface. We restore continuous soffit ventilation so the attic airflow that keeps the eave dry (and helps prevent ice dams) stays intact.

WHAT’S INCLUDED

Fascia & Soffit in Meridian — what we cover.

  • Tear-out of rotted, soft, or spongy fascia board
  • Removal and replacement of stained or decayed soffit panels
  • Inspection and treatment of rafter tails / sub-fascia behind the boards
  • Rebuild in rot-resistant material (PVC, composite, cement/Hardie, or aluminum-wrapped wood)
  • Soffit ventilation restored so attic airflow stays correct
  • Gutters re-pitched and re-hung off a solid nailing surface

Want a quick range for fascia & soffit in Meridian? Fascia and soffit repair is priced by linear footage and the extent of the rot — sound-wood replacement is cheaper than tearing into water-damaged board that's spread to the soffit and rafter tails. Material choice (PVC, composite, cement, aluminum-wrap, cedar) and story count also move the number. We work from national professional ranges adapted to the Treasure Valley because no Idaho-specific published per-foot figure exists; the on-site visit produces the written quote.

Open the calculator →

COST RANGE

How much does fascia & soffit cost in Meridian?

Fascia & Soffitpricing depends entirely on the scope of the work — the size of the affected area, the underlying cause, and what the repair or prevention plan involves. We don’t publish a flat range because an honest number requires seeing the job in person.

Get a free on-site estimate and we’ll give you a written, itemized quote — no guesswork, no obligation.

These are Treasure Valley ranges only — the on-site visit gives the real number. Actual cost depends on roof access, story count, existing condition, and the system selected.

WHY US

Why Meridian homeowners choose us.

Stop the cascade from fascia rot into soffit and roof framing

Give your gutters a solid board to bolt back into

Rebuild in materials that resist the moisture rot that destroys bare wood

Protect the eaves on older Boise homes with century-old wood detailing

SERVING MERIDIAN

Neighborhoods we serve in Meridian.

Downtown MeridianThe VillageSouth MeridianNorth MeridianParamount

If your address isn’t listed, call (208) 247-2660 — we likely still cover it.

Frequently asked questions

How much does fascia and soffit repair cost in the Treasure Valley?

No Idaho-specific published per-foot figure exists, so we work from national professional ranges adapted to the Treasure Valley: roughly $6–$20 per linear foot installed for sound-wood replacement, and about $10–$23 per linear foot where water or rot damage is involved. A typical whole-home fascia project nationally lands in the $1,050–$3,300 range. The variables are the same here as anywhere — total footage, how far the rot has spread into the soffit and rafter tails, story count, and the replacement material. We give you a written number on-site.

What causes fascia rot in the first place?

Almost always the gutters. When gutters clog, overflow, slope the wrong way, or pull slightly away from the house, water saturates the wood fascia behind them. That perpetual dampness pushes paint off from the inside out and breaks down the wood fibers until the board goes soft. Water running down the rotting fascia then drips onto the soffit below, so soffit decay is typically a cascade failure that follows the fascia. Prolonged wetness can extend the rot into the roof framing behind the boards.

Can you replace the fascia and re-hang my gutters in one visit?

Yes — and that's the right way to do it. As a licensed Idaho gutter contractor (RCE-6681702), we coordinate the carpentry and the gutter work together: tear out the rot, rebuild on solid rot-resistant material, then re-pitch and re-hang the gutters off the new board. You cannot properly re-hang gutters on rotted fascia, which is why a gutter that keeps pulling away is often a fascia problem first.

What material do you replace rotted fascia with?

It depends on budget and the look you want. PVC and composite (roughly $3–$7/ft material, national ranges) and aluminum-wrapped wood (aluminum trim runs higher) resist the moisture rot that destroys bare wood, so they're our usual recommendation in a gutter-fed eave. Cedar and cement/Hardie are also options. We talk through the tradeoffs on-site rather than defaulting to whatever's cheapest.

How do ice dams damage fascia and soffit?

Ice dams form when attic heat melts roof snow during the day and it refreezes at the cold eave overnight. After repeated freeze-thaw cycles, meltwater backs up under the shingles and into the eave, soffit, and fascia area. Boise averages about 17.6 inches of snow over roughly 18 snow days a year (NOAA 1991–2020 normals), so that melt-and-refreeze pattern is a recurring driver of eave rot here. The National Weather Service recommends at least R-30 attic insulation plus continuous soffit-to-ridge ventilation to keep the attic cold and minimize the cycle — which is why restoring soffit ventilation is part of our repair.

Why do older Boise homes need fascia repair so often?

Boise's North End Historic District has a period of significance of 1891–1915, with the area platted in 1878 — so there's a large stock of homes well over a century old, with original-era wood eave detailing. That kind of aged wood fascia and soffit is a prime rot-repair candidate, and it's often paired with a seamless-gutter replacement when the old system has been feeding water behind the boards for years.
Request OnlineGet a Free Estimate

Ready for Fascia & Soffit in Meridian?

Call (208) 247-2660 or get a free estimate. Licensed Idaho contractor serving Meridian and the Treasure Valley.